Echo CS-341 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Benzínový nástroj Echo CS-341. Echo CS-341 User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 32
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
X7503206104
X750009894
04/12
WARNING
Users of this equipment risk injury to themselves and others if the unit is used im-
properly and/or safety precautions are not followed. ECHO provides an operator’s
manual and a safety manual. Both must be read and understood for proper and safe
operation. Failure to do so could result in serious injury.
Chain Saw
Instruction Manual
MODEL : CS-341
Zobrazit stránku 0
1 2 3 4 5 6 ... 31 32

Shrnutí obsahu

Strany 1 - MODEL : CS-341

X7503206104X75000989404/12 WARNING Users of this equipment risk injury to themselves and others if the unit is used im-properly and/or safety pre

Strany 2 - Rules foR safe opeRation

10Handling Fuel DANGERFuel is VERY ammable. Use extreme care when mixing, storing or handling or serious personal injury may result.• Use an approv

Strany 3 - WARNING

1111ABCOPERATIONSTARTING COLD ENGINE WARNINGMake sure bar and chain are not touching anything when startingthe saw.1. Move chain brake lever fully fo

Strany 4 - Contents

12when engine is haRD to staRt WARNING Clutch engages and chain may rotate when engine is started with throttle control latch engaged. Never use the

Strany 5

13Running WARNING The saw chain should not move at idle, otherwise serious per-sonal injury may result.NOTEIf saw chain moves adjust carburetor acco

Strany 6 - DesCRiption

14 WARNING Read the ECHO “CHAIN SAW SAFETY MANUAL” included with your chain saw for additional cutting and safety instruc-tions. Failure to obey all

Strany 7

15 WARNING A falling tree can seriously damage anything it may hit - a car, a house, a fence, a power line, or another tree. There are ways to make

Strany 8 - baR anD saw Chain-install/

16BUCKINGUphill positionFINISH CUTFIRST CUTBoard or at stonesKICKBACK• Improper thrust cutting.• When the bar nose hits another tree, etc.Don’t cut

Strany 9 - statement

17maintenanCe anD CaRe WARNINGMoving parts can amputate ngers or cause severe injuries. Keep hands, clothing and loose objects away from all opening

Strany 10 - lubRiCant

18ABCDEFaiR filteR1. Close choke (A) (Cold Start Position [ ). This prevents dirt from entering the carburetor throat when the air lter is removed.

Strany 11 - WARNING

19SPROCKET• A damaged sprocket (C) will cause premature damage or wear of saw chain.• Clean sprocket, clutch and bar mount area before instal-lation

Strany 12 - engine is haRD to staRt

2Rules foR safe opeRationA. Kickback Safety Precaution for Chain Saw UsersB. Other Safety Precautions1. Do not operate a chain saw with one hand! Se

Strany 13 - waRm engine

20muffleR spaRk aRRestoRIMPORTANT Carbon deposits in mufer will cause a drop in engine output and overheating. Spark arrestor screen must be checke

Strany 14 - Cutting instRuCtions

21Exhaust Port CleaningLevel 2.Parts Required: As needed: Mufer Gasket 1. Remove spark plug lead. 2. Remove mufer cover screws and remove muf

Strany 15 - WARNING

22CaRbuRetoR aDjustmentEngine Break-InNew engines must be operated a minimum duration of two tanks of fuel break-in before carburetor ad-justments can

Strany 16

23IMPORTANTChain and guide bar gauge size must be identical. Use Bar/Chain combinations shown in table above.IMPORTANTIf your kick guard is damaged or

Strany 17 - inteRvals

24SETTING THE SAW CHAINFor setting saw chains, round le (4 mm: 5/32”) and at le are used.• To keep correct position and correct angle, use the le

Strany 18 - stRaineR

25tRoubleshootingPoor performance of the engine and/or cutting mechanism can normally be prevented by carefully following these instructions.Poor perf

Strany 19 - baR anD oil holes

26CoRReCt use of Chain bRakeThe installation of a chain brake may be mandatory by law or as stipulated by insurance regulations in your area of opera

Strany 20 - system Cleaning

27TESTING THE BRAKE• Start the engine on a solid level surface and run at a fast idle until warm.• Hold the saw rmly by the handles and accelerate

Strany 21 - Exhaust Port Cleaning

28waRRanty statementsECHO LIMITED WARRANTY STATEMENT FOR PRODUCT SOLD IN USA AND CANADA BEGINNING 01/01/2010ECHO'S RESPONSIBILITYECHO Incorporate

Strany 22 - aDjustment

29PURCHASED REPAIR PARTS, SHORT BLOCKS AND ACCESSORIES

Strany 23

311. Shut off the engine before setting the chain saw down.12. Use extreme caution when cutting small size brush and saplings because slender material

Strany 24 - CHAIN TYPE AND SPROCKET PITCH

30 ECHO INCORPORATED EMISSION CONTROL WARRANTY STATEMENTFOR ECHO AND SHINDAIWA BRANDSThe Environmental Protection Agency (EPA) and the California Air

Strany 26 - STORAGE AFTER USE

CONSUMER PRODUCTSUPPORT1-800-673-15588:30 - 4:30 Mon - Fri C.S.T.ECHO, INCORPORATED400 OakwOOd ROadLake ZuRich, iL 60047-1564www.echo-usa.comC0761100

Strany 27 - OPERATION

4inteRnational symbolsContents

Strany 28

5Model ... CS-341Dimension L x W x H ...

Strany 29 - 11/18/2011

6emission DataDesCRiptionThe ECHO product you purchased has been factory pre-assembled for your convenience. Due to packaging restric-tions, guide bar

Strany 30 - 99922201033

7 1. Hand guard (Chain brake locking lever) 2. Throttle control lockout 3. Throttle control trigger 4. Sprocket guard 5. Chain catcher

Strany 31

8 WARNINGIMPROPER CLUTCH COVER ASSEMBLY CAN RE-SULT IN SERIOUS INJURY, AND WILL CAUSE SE-VERE SAW DAMAGE IF UNIT IS STARTED. NEVER START OR OPERATE SA

Strany 32 - oR ReplaCement manuals

9aDjustment, Chain tensionIMPORTANTAlways loosen guide bar nuts before turning chain tension adjuster, otherwise clutch cover and tensioner will be da

Komentáře k této Příručce

Žádné komentáře