Echo SRM - 2110 Uživatelský manuál stáhnout pdf (Strana 17)

RASS

RIMMER

RUSH

UTTER

PERATOR

ANUAL

U-HANDLE INSTALLATION

Tools Required: 8mm x 10mm Open End Wrench, Slotted Screw-

driver, (3mm Hex Wrench SRM-2100 only.)

Parts Required: U-Handle Kit. (SRM-2100) P/N 35130454130

NOTE

On model SRM-2110 use Steps 1, 10, 11 and 13 - 17 only.

1. Close choke and remove air filter cover.

2. Disconnect ignition stop leads (C).

3. Remove inner throttle linkage from carburetor swivel (B).

4. Loosen nut (A) and remove throttle linkage from bracket.

5. Loosen two (2) bolts (D) and pull drive shaft assembly from clutch

case.

6. Loosen two (2) rear handle screws (E) and pull rear handle (F)

from the drive shaft assembly.

7. Loosen four (4) screws and remove front handle (G).

8. Position Lower U-Handle Bracket (H) 400mm (15-3/4 in.) from

engine end of drive shaft. Secure with three (3) 5mm x 30mm

bolts.

9. Install harness hook (included with Blade Conversion Kit) for blade

use. Position 220 mm (8-5/8 in.) from engine end of drive shaft

assembly. DO NOT tighten at this time.

10. Install upper U-Handle and bracket on lower bracket and secure

with one (1) 8mm x 55mm bolt (J) and large circular washer.

400 mm (15-3/4 in.)

220 mm

(8-21/32 in.)

ENGINE

END

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

Žádné komentáře

Echo SRM - 2110 Uživatelský manuál Strana 17