Echo PE-230 Uživatelský manuál stáhnout pdf (Strana 22)

BLADE REPLACEMENT/LUBRICATION

Level 1.

Tools Required: Scrench, Locking Tool, Needle Nose Pliers, 13 mm

Open End Wrench

Parts Required: ECHO

LUBE

8 oz. (P/N 91014) or Lithium Base

Grease, Blade P/N 69601552632, split pin P/N

90030020022

NOTE

Grease gear case every 50 hours of use. Replace blade when it is

worn shorter than 6 inches. Remove blade and holders before

greasing to prevent damage to gear and bearings.

1. Shut engine off.

2. Remove split pin (A).

3. Rotate blade until holes in inner blade adapter (B) and gear box

align. Insert locking tool supplied to lock PTO shaft (C).

NOTE

Shield cover not shown for illustration clarity.

NOTE

Blade nut (D) is left hand thread.

4. Remove blade nut (D) in a clockwise direction using box wrench

supplied. Remove outer blade adapter (E), blade (F) and inner blade

adapter (B).

5. Remove plug (G) and grease gear housing. Do not over fill - grease

will emerge between PTO shaft (C) and seal when over full.

6. Install inner blade adapter (B) onto PTO shaft (C).

7. Install and center new blade (F) onto inner adapter (B).

8. Install outer adapter (E) and nut (D). Tighten nut (D) firmly,

counterclockwise (CCW).

IMPORTANT

Never reuse old split pin.

9. Install new split pin (A) to secure nut.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Žádné komentáře

Echo PE-230 Uživatelský manuál Strana 22